Slab Stabilization

Slab stabilization seeks to fill voids beneath the slab caused by pumping, consolidation or other means. If left untreated, these voids, which are often quite small (on the order of 3 mm (0.125 inches) deep), may cause other problems such as faulting, corner breaks or cracking (ACPA, 1995[1]). Voids are typically filled by pumping grout through holes drilled through the slab.

Purpose

Preventive and corrective maintenance. Restores proper base/subgrade slab support to prevent more serious distresses such as faulting, corner breaks and cracking.

Materials

Pozzolan-cement grout.

Other Information

Slab stabilization only fills the voids under a slab, it should not be confused with slab jacking, which is used to raise the elevation of a depressed slab.



Footnotes    (↵ returns to text)
  1. American Concrete Pavement Association (ACPA).  (1995).  Construction of Portland Cement Concrete Pavements.  National Highway Institute Course No. 13133.  AASHTO/FHWA/Industry joint training.  Federal Highway Administration, Department of Transportation.  Washington, D.C.

 

 

 

Check out the new Pavement Interactive at beta.pavementinteractive.org

We have been working hard to improve the Pavement Interactive experience.

The improvements include: