Studded Tire Information

Tire studs are small metal protrusions inserted into winter tires to improve tire-road friction in snow or ice conditions.  In addition to this friction improvement studded tires also have an unwanted and detrimental side effect: increased pavement wear.

History

Studded tires have been around in one form or another since about 1890.  Modern studded tires first took off in popularity in the 1950s in Scandinavia where they were used to increase traction on icy roads.  Studded tires then took hold in the U.S. in the 1960s and enjoyed growing popularity into the 1970s.  The 1970s saw the first significant research efforts aimed at assessing their safety and pavement wear effects.  The late 1970s through the 1990s produced technical improvements in studded tires as well as widespread governmental restrictions on their use in an effort to limit pavement wear.

Description

The typical studded tire (see Figure 1) is a winter tire with between 60 and 120 inserted small metal studs.  These studs are usually made of tungsten carbide (an extremely hard metal), weigh 1.7 – 1.9 grams each and protrude about 1.2 – 1.5 mm from the tire surface.  Studs are made by embedding a small metal “jacket” into the tire then inserting a tungsten carbide pin into the jacket (see Figure 2).  This pin is tapered so that it will move back into the jacket when the dynamic forces acting on it reach a certain critical level.  If this subtle stud movement is properly calibrated the result is a tire stud that maintains a near-constant protrusion length even as the rest of the tire wears down.  This type of stud is called a controlled protrusion (CP) stud.

 

Studded tire.
Figure 1: Studded tire.

Problems with Studded Tires

Although studded tires increase traction on icy surfaces, in the early 1970s various studies throughout the U.S. and internationally began to identify significant problems with studded tires:

  • Studded tires may not offer any safety advantages in comparison to modern radial winter tires in non-icy road conditions.  In fact, studs may decrease tire-road friction in these situations.  For more information see:

Scheible, R.  (October 2002).  An Overview of Studded and Studless Tire Traction and Safety.  WSDOT Research Report WA-RD 551.1.  Washington State Transportation Center (TRAC), Washington State Department of Transportation.

  • Studded tires have been shown to cause significant damage to both flexible and rigid pavements.  Specifically, they:
    • Create ruts which fill with ice and water creating spray and hydroplaning.
    • May polish some aggregates, which reduces skid resistance and creates a more slippery driving surface.
    • Remove pavement markings.

 

Studded tire damage on I-90 in Idaho.
Figure 3. Studded tire damage on I-90 in Idaho.

Studded tire damage on I-90 in Idaho.
Figure 4. Studded tire damage on I-90 in Idaho.

Studded tire damage on I-80 in California over Donner Pass.
Figure 5. Studded tire damage on I-80 in California over Donner Pass.

Studded tire damage on I-80 in California over Donner Pass.
Figure 6. Studded tire damage on I-80 in California over Donner Pass.

Two cores taken from the same pavement. The core on the left was taken from the wheelpath and subjected to heavy studded tire wear. The core on the right was not from the wheelpath and was thus not subjected to much studded tire wear. The difference in height between the two cores is due almost entirely to studded tire wear.
Figure 7. Two cores taken from the same pavement. The core on the left was taken from the wheelpath and subjected to heavy studded tire wear. The core on the right was not from the wheelpath and was thus not subjected to much studded tire wear. The difference in height between the two cores is due almost entirely to studded tire wear.

Pavement Damage

Studded tires cause significant pavement damage. When they strike the pavement surface, each small tungsten carbide pin causes a small amount of pavement material to dislodge from the overall pavement structure. This pavement damage is influenced by the following five factors:

  1. Stud protrusion length. The greater the protrusion, the greater the pavement wear.
  2. Stud weight. The heavier the stud, the greater the pavement wear.
  3. Number of studs per tire. The more studs per tire, the greater the pavement wear per tire.
  4. Vehicle speed. The greater the speed the greater the pavement wear.
  5. Type of pavement surface course. Open-graded HMA tends to wear more quickly than dense-graded HMA or SMA. PCC pavement is also subject to studded tire wear (see Figures 5 and 6).

Many studies have been done to quantify studded tire pavement wear and they have given widely varying results. Based on data summarized by Angerinos et al. (1999[1]), a rough rule-of-thumb would be that studded tire wear causes about 0.1 inches of wheelpath wear per million studded tire passes. This may not seem significant, however many major urban U.S. highways experience a directional traffic volume in excess of 100,000 vehicles per day, of which anywhere from about zero to 60 percent of the automobiles within this traffic are equipped with studded tires in the U.S. In Finland, studded tire use is estimated at above 90 percent for automobiles.

Studded tire pavement damage has resulted in the following:

  • Some countries (e.g., Japan, Germany, Holland, Belgium) and U.S. States (e.g., Minnesota, Illinois, Maryland) have banned the use of studded tires.
  • States that allow studded tire use usually only allow it during the winter season. Typically, studded tires are allowed from the beginning of October or November through the end of March or April.
  • For those states that allow studded tire use, the estimated annual expenditures of extra road maintenance resulting from pavement damage caused by studded tire use tend to be in excess of $10 million.
  • Open-graded wearing courses are highly susceptible to studded tire wear. Thus, many states that allow studded tires do not use open-graded wearing courses.

In sum, studded tires do increase tire-pavement friction on icy roads but they also may reduce tire-pavement friction on non-icy roads and they definitely do increase pavement wear. A typical passenger car produces negligible pavement damage (typically < 0.0001 ESALs per car) and can thus be ignored in pavement structural design. However, the same typical passenger car equipped with studded tires becomes a significant pavement damage concern (in the form of studded tire ruts) and must be accounted for through use restrictions, maintenance costs and mix design.



Footnotes    (↵ returns to text)
  1. A Synthesis on Studded Tires.  Washington State Department of Transportation Research Report WA-RD 471.1.  Washington State Department of Transportation.  Olympia, WA.